Preface xiii
1 IoT-Based Battery Management System for Hybrid Electric Vehicle 1
Sivaraman Palanisamy and Sharmeela Chenniappan
1.1 Introduction 1
1.2 Battery Configurations 3
1.3 Types of Batteries for HEV and EV 5
1.4 Functional Blocks of BMS 6
1.4.1 Components of BMS System 7
1.5 IoT-Based Battery Monitoring System 11
References 14
2 A Noble Control Approach for Brushless Direct Current Motor Drive Using Artificial Intelligence for Optimum Operation of the Electric Vehicle 17
Upama Das, Pabitra Kumar Biswas and Chiranjit Sain
2.1 Introduction 18
2.2 Introduction of Electric Vehicle 19
2.2.1 Historical Background of Electric Vehicle 19
2.2.2 Advantages of Electric Vehicle 20
2.2.2.1 Environmental 20
2.2.2.2 Mechanical 20
2.2.2.3 Energy Efficiency 20
2.2.2.4 Cost of Charging Electric Vehicles 21
2.2.2.5 The Grid Stabilization 21
2.2.2.6 Range 21
2.2.2.7 Heating of EVs 22
2.2.3 Artificial Intelligence 22
2.2.4 Basics of Artificial Intelligence 23
2.2.5 Advantages of Artificial Intelligence in Electric Vehicle 24
2.3 Brushless DC Motor 24
2.4 Mathematical Representation Brushless DC Motor 25
2.5 Closed-Loop Model of BLDC Motor Drive 30
2.5.1 P-I Controller & I-P Controller 31
2.6 PID Controller 32
2.7 Fuzzy Control 33
2.8 Auto-Tuning Type Fuzzy PID Controller 34
2.9 Genetic Algorithm 35
2.10 Artificial Neural Network-Based Controller 36
2.11 BLDC Motor Speed Controller With ANN-Based PID Controller 37
2.11.1 PID Controller-Based on Neuro Action 38
2.11.2 ANN-Based on PID Controller 38
2.12 Analysis of Different Speed Controllers 39
2.13 Conclusion 41
References 42
3 Optimization Techniques Used in Active Magnetic Bearing System for Electric Vehicles 49
Suraj Gupta, Pabitra Kumar Biswas, Sukanta Debnath and Jonathan Laldingliana
3.1 Introduction 50
3.2 Basic Components of an Active Magnetic Bearing (AMB) 54
3.2.1 Electromagnet Actuator 54
3.2.2 Rotor 54
3.2.3 Controller 55
3.2.3.1 Position Controller 56
3.2.3.2 Current Controller 56
3.2.4 Sensors 56
3.2.4.1 Position Sensor 56
3.2.4.2 Current Sensor 57
3.2.5 Power Amplifier 57
3.3 Active Magnetic Bearing in Electric Vehicles System 58
3.4 Control Strategies of Active Magnetic Bearing for Electric Vehicles System 59
3.4.1 Fuzzy Logic Controller (FLC) 59
3.4.1.1 Designing of Fuzzy Logic Controller (FLC) Using MATLAB 60
3.4.2 Artificial Neural Network (ANN) 63
3.4.2.1 Artificial Neural Network Using MATLAB 63
3.4.3 Particle Swarm Optimization (PSO) 67
3.4.4 Particle Swarm Optimization (PSO) Algorithm 68
3.4.4.1 Implementation of Particle Swarm Optimization for Electric Vehicles System 70
3.5 Conclusion 71
References 72
4 Small-Signal Modelling Analysis of Three-Phase Power Converters for EV Applications 77
Mohamed G. Hussien, Sanjeevikumar Padmanaban, Abd El-Wahab Hassan and Jens Bo Holm-Nielsen
4.1 Introduction 77
4.2 Overall System Modelling 79
4.2.1 PMSM Dynamic Model 79
4.2.2 VSI-Fed SPMSM Mathematical Model 80
4.3 Mathematical Analysis and Derivation of the Small-Signal Model 86
4.3.1 The Small-Signal Model of the System 86
4.3.2 Small-Signal Model Transfer Functions 87
4.3.3 Bode Diagram Verification 96
4.4 Conclusion 100
References 100
5 Energy Management of Hybrid Energy Storage System in PHEV With Various Driving Mode 103
S. Arun Mozhi, S. Charles Raja, M. Saravanan and J. Jeslin Drusila Nesamalar
5.1 Introduction 104
5.1.1 Architecture of PHEV 104
5.1.2 Energy Storage System 105
5.2 Problem Description and Formulation 106
5.2.1 Problem Description 106
5.2.2 Objective 106
5.2.3 Problem Formulation 106
5.3 Modeling of HESS 107
5.4 Results and Discussion 108
5.4.1 Case 1: Gradual Acceleration of Vehicle 108
5.4.2 Case 2: Gradual Deceleration of Vehicle 109
5.4.3 Case 3: Unsystematic Acceleration and Deceleration of Vehicle 110
5.5 Conclusion 111
References 112
6 Reliability Approach for the Power Semiconductor Devices in EV Applications 115
Krishnachaitanya, D., Chitra, A. and Biswas, S.S.
6.1 Introduction 115
6.2 Conventional Methods for Prediction of Reliability for Power Converters 116
6.3 Calculation Process of the Electronic Component 118
6.4 Reliability Prediction for MOSFETs 119
6.5 Example: Reliability Prediction for Power Semiconductor Device 121
6.6 Example: Reliability Prediction for Resistor 122
6.7 Conclusions 123
References 123
7 Modeling, Simulation and Analysis of Drive Cycles for PMSM-Based HEV With Optimal Battery Type 125
Chitra, A., Srivastava, Shivam, Gupta, Anish, Sinha, Rishu, Biswas, S.S. and Vanishree, J.
7.1 Introduction 126
7.2 Modeling of Hybrid Electric Vehicle 127
7.2.1 Architectures Available for HEV 128
7.3 Series—Parallel Hybrid Architecture 129
7.4 Analysis With Different Drive Cycles 129
7.4.1 Acceleration Drive Cycle 130
7.4.1.1 For 30% State of Charge 130
7.4.1.2 For 60% State of Charge 131
7.4.1.3 For 90% State of Charge 131
7.5 Cruising Drive Cycle 132
7.6 Deceleration Drive Cycle 132
7.6.1 For 30% State of Charge 134
7.6.2 For 60% State of Charge 136
7.6.3 For 90% State of Charge 137
7.7 Analysis of Battery Types 139
7.8 Conclusion 140
References 141
8 Modified Firefly-Based Maximum Power Point Tracking Algorithm for PV Systems Under Partial Shading Conditions 143
Chitra, A., Yogitha, G., Karthik Sivaramakrishnan, Razia Sultana, W. and Padmanaban, S.
8.1 Introduction 143
8.2 System Block Diagram Specifications 146
8.3 Photovoltaic System Modeling 148
8.4 Boost Converter Design 150
8.5 Incremental Conductance Algorithm 152
8.6 Under Partial Shading Conditions 153
8.7 Firefly Algorithm 154
8.8 Implementation Procedure 156
8.9 Modified Firefly Logic 157
8.10 Results and Discussions 159
8.11 Conclusion 162
References 162
9 Induction Motor Control Schemes for Hybrid Electric Vehicles/Electric Vehicles 165
Sarin, M.V., Chitra, A., Padmanaban, S. and Venkadesan, A.
9.1 Introduction 166
9.2 Control Schemes of IM 167
9.2.1 Scalar Control 167
9.3 Vector Control 168
9.4 Modeling of Induction Machine 169
9.5 Controller Design 174
9.6 Simulations and Results 175
9.7 Conclusions 176
References 177
10 Intelligent Hybrid Battery Management System for Electric Vehicle 179
Rajalakshmi, M. and Razia Sultana, W.
10.1 Introduction 179
10.2 Energy Storage System (ESS) 181
10.2.1 Lithium-Ion Batteries 183
10.2.1.1 Lithium Battery Challenges 183
10.2.2 Lithium–Ion Cell Modeling 184
10.2.3 Nickel-Metal Hydride Batteries 186
10.2.4 Lead-Acid Batteries 187
10.2.5 Ultracapacitors (UC) 187
10.2.5.1 Ultracapacitor Equivalent Circuit 187
10.2.6 Other Battery Technologies 189
10.3 Battery Management System 190
10.3.1 Need for BMS 191
10.3.2 BMS Components 192
10.3.3 BMS Architecture/Topology 193
10.3.4 SOC/SOH Determination 193
10.3.5 Cell Balancing Algorithms 197
10.3.6 Data Communication 197
10.3.7 The Logic and Safety Control 198
10.3.7.1 Power Up/Down Control 198
10.3.7.2 Charging and Discharging Control 199
10.4 Intelligent Battery Management System 199
10.4.1 Rule-Based Control 201
10.4.2 Optimization-Based Control 201
10.4.3 AI-Based Control 202
10.4.4 Traffic (Look Ahead Method)-Based Control 203
10.5 Conclusion 203
References 203
11 A Comprehensive Study on Various Topologies of Permanent Magnet Motor Drives for Electric Vehicles Application 207
Chiranjit Sain, Atanu Banerjee and Pabitra Kumar Biswas
11.1 Introduction 208
11.2 Proposed Design Considerations of PMSM for Electric Vehicle 209
11.3 Impact of Digital Controllers 211
11.3.1 DSP-Based Digital Controller 212
11.3.2 FPGA-Based Digital Controller 212
11.4 Electric Vehicles Smart Infrastructure 212
11.5 Conclusion 214
References 215
12 A New Approach for Flux Computation Using Intelligent Technique for Direct Flux Oriented Control of Asynchronous Motor 219
A. Venkadesan, K. Sedhuraman, S. Himavathi and A. Chitra
12.1 Introduction 220
12.2 Direct Field-Oriented Control of IM Drive 221
12.3 Conventional Flux Estimator 222
12.4 Rotor Flux Estimator Using CFBP-NN 223
12.5 Comparison of Proposed CFBP-NN With Existing CFBP-NN for Flux Estimation 224
12.6 Performance Study of Proposed CFBP-NN Using MATLAB/SIMULINK 225
12.7 Practical Implementation Aspects of CFBP-NN-Based Flux Estimator 229
12.8 Conclusion 231
References 231
13 A Review on Isolated DC–DC Converters Used in Renewable Power Generation Applications 233
Ingilala Jagadeesh and V. Indragandhi
13.1 Introduction 233
13.2 Isolated DC–DC Converter for Electric Vehicle Applications 234
13.3 Three-Phase DC–DC Converter 238
13.4 Conclusion 238
References 239
14 Basics of Vector Control of Asynchronous Induction Motor and Introduction to Fuzzy Controller 241
S.S. Biswas
14.1 Introduction 241
14.2 Dynamics of Separately Excited DC Machine 243
14.3 Clarke and Park Transforms 244
14.4 Model Explanation 251
14.5 Motor Parameters 252
14.6 PI Regulators Tuning 254
14.7 Future Scope to Include Fuzzy Control in Place of PI Controller 256
14.8 Conclusion 257
References 258
Index 259
